Tri-M Systems MOPS/586 User Manual

MOPS/586Technical ManualRev. 1.4JUMPtecIndustrielle Computertechnik AGBrunnwiesenstraße 1694469 Deggendorf/ GermanyTri-M Systems Inc., 6-1301 Ketch C

MOPS/586 Block Diagram Block Diagram CPUDRAMALIChipsetCacheRTCEIDEBIOSIO-Con-trollerEthernet-Con-trollerCOM1COM2LPT110baseTISA-Con.Tri-M Systems Inc.,

MOPS/586 Connector Arrangement Connector Arrangement Tri-M Systems Inc., 6-1301 Ketch Court, Coquitlam, B.C., V3K 6X7, CanadaPhone: (604) 527-1100, (8

MOPS/586 BIOS-Description BIOS-Description The Standard AMI-BIOS is located in the Flash EPROM onboard. This device has 8 bit wide access. 16 bitacces

MOPS/586 BIOS-Description• WPcom (starting write precompensation cylinder)• Sec (number of sectors) Parameter Description Type The number for a d

MOPS/586 BIOS-Description Advanced CMOS Setup Quick Boot Set this option to Enabled to instruct AMIBIOS to boot quickly when the computer is powered o

MOPS/586 BIOS-Description Wait For 'F1' if Error If this option is Enabled the system will wait on power up for the user to press the <F1

MOPS/586 BIOS-Description Power Management Setup Power Management/APM If this option is Disabled, none of the below listed options are available, the

MOPS/586 BIOS-DescriptionPeripheral Setup Onboard IDE This option enables the onboard IDE controller. The settings are Disabled and Enabled. The Optim

MOPS/586 BIOS-Description This option enables the silicon state disk as either drive 80h, 81h, 82h, or 83h (C, D, E or F). Thesettings are Disabled, 8

MOPS/586 BIOS-Description AMIBIOS Configuration Screen AMIBIOS System Configuration (C) 1985-1996, American Megatrends Inc.,Main Processor : Am5x

MOPS/586 Table of ContentsTable of ContentsTABLE OF CONTENTS...

MOPS/586 Hardware Description Hardware Description ALI-Chipset Features The MOPS/586 Board operates with the chipset ALI 1489/87, which provides follo

MOPS/586 Hardware DescriptionInterruptsIRQ0 System TimerIRQ1 KeyboardIRQ2 CascadeIRQ3 COM 2 note (1)IRQ4 COM 1 note (1)IRQ5 Ethernet (default) note

MOPS/586 Hardware Description The JIDA StandardJIDA is the abbreviation for JUMPtec® Intelligent Device Architecture.Every board with onboard BIOS ext

MOPS/586 Hardware DescriptionGet Manufacturing DateInt 15hInput:AX = EA02h DX = 4648hCL = Board numberOutput:CL=0: Board presentCL≠0: Board not presen

MOPS/586 Hardware DescriptionRead Running Time MeterInt 15hInput:AX = EA07h DX = 4648hCL = Board numberOutput:CL=0: Board presentCL≠0: Board not prese

MOPS/586 Hardware DescriptionWatchdog ExtensionWith the aid of a special Interrupt 15h function, the watchdog on a JUMPtec board can be controlledvery

MOPS/586 Network OperationReturns noExamplemov ax,0E000h ; Watchdog setmov bx,5 ; 5*0,2s = 1s Timeoutmov cx,5 ; 5*0,2s = 1s Delaymov dx,0 ; after Time

MOPS/586 SpecificationsSpecificationsMechanical SpecificationsPC/104 Bus connector: 2 pieces of 2*32 pin male and 2*20 pin male connectorModule-dimen

MOPS/586 Peripheral InterfacePeripheral InterfaceKeyboard, Reset, Battery, SpeakerPin SignalnameFunction 5-pin diodekeyboardadapter6-pin minidinkeyboa

MOPS/586 Peripheral Interface1 (Speaker)2 (GND)3,10 (PowerGood)4 (/KLOCK)5 (KDATA)6 (KCLK)7 (GND)8 (+ 5V)9 (VBAT)35241Serial Port COM 1, 2 (RS232C)Pin

MOPS/586 Table of ContentsFLOPPY CONNECTOR...

MOPS/586 Peripheral InterfaceParallel Port LPT 1Pin Signalname Function In / Out DSUB-25(need Adapter)1 /Strobe Out 13 Data 0 I/O 25 Data 1 I/O 37 Dat

IDE Connector for 2,5" Hard DiskPin Signal Pin Signal1 /RESET 2 GND3 D7 4 D85 D6 6 D97 D5 8 D109 D4 10 D1111 D3 12 D1213 D2 14 D1315 D1 16 D1417

MOPS/586 Peripheral InterfacePower ConnectorPin Pin function1 GND2 +5V3 keypin4 +12V5 -5V6 -12V7 GND8 +5VPower PinsThe MOPS/586 is a +5 V only module.

MOPS/586 Peripheral InterfacePC/104-ConnectorSpecification XT BusPin Signal Name Pin Signal NameA1 /IOCHCK B1 GNDA2 SD7 B2 RESETDRVA3 SD6 B3 +5VA4 SD5

MOPS/586 Literature, Standards, LinksLiterature, Standards, LinksPC/104-Bus• PC/104 Specification Version 2.3 June 1996PC/104 Consortium; www.pc104.

MOPS/586 Document Revision HistoryDocument Revision HistoryFilename Date Edited by Alteration to preceding revisionP488M210 10.09.98 KW CreatedP488M21

MOPS/586 User InformationUser InformationCopyright 1997 JUMPtec® Industrielle Computertechnik AG.In this document JUMPtec® Industrielle Computertechni

MOPS/586 User InformationWarrantyEach board is tested carefully and thoroughly before being shipped. If, however, problems should occur duringthe oper

MOPS/586 FeaturesFeatures• ProcessorAMD Am5x86® with 133 MHz internal Clock and 16 kByte write-back-Cache• Chipset ALI 1489/1487 PCI Chipset• Power

MOPS/586 I/O Map I/O Map The I/O-port addresses of the processor module MOPS/586 are functionally identical with a standard PC/AT. I/O Addresses MO

MOPS/586 Memory Map for BIOS, SSD and JRC SupportMemory Map for BIOS, SSD and JRC Support The BIOS includes two special extensions to support the onbo

MOPS/586 Onboard SSD (DOS-compatible)Expanded Memory MapThe user can convert (up to 20Mbytes) Extended Memory into Expanded Memory (EMS). The selected